 |
F20E-Gfk560/630
F21E-Gfk630/710
F23E-Gfk800Y
Flyer payoff with glass fibre arm to put in
bobbin holeFlyer payoff for use of single
wire and multiwire with high speed (max. 800 m/min). Purpose in most
cases is rewinding. The unit should be only used with adequate shielding
available on request.
Flange Ø : 560-800mm
Multiwire : max. 8 x 0,65mm
Ø Cu-, Al wire : 0,15-1mm
Ø Steelwire hard : max. 0,5mm
Ø Steelwire soft : max. 0,7mm
Wire speed max. : 800 m/min
Wire tension : 1N - 15N |
 |
F20G-Gfk560/630HTK
F21G-Gfk630/710YHTK
F23G-Gfk800HTK
Flyer payoff with glass fibre, mounted in
frame, with dancer accumulator and wire tension compensator
Flyer payoff for use of single wire and multiwire with
high speed (max.800m/min). Purpose in most cases is rewinding, for
example braiding spools.
Flange Ø : 560-800mm
Multiwire : max. 8 x 0,65mm
Ø Cu-, Al wire : 0,15-1mm
Ø Steelwire hard : max. 0,5mm
Ø Steelwire soft : max. 0,7mm
Wire speed max. : 800 m/min
Wire tension : 1N - 15N |
 |
F21G-Gfk560/800HTK-Y
High Speed Flyer Payoff with following hysteresis brake
For the possibility to increase tension there is a
hysteresis brake following as shown on the picture. This kind of Flyer
Payoffs are equipped with glass fibre arms and pulleys made of plastic
with ceramic surface. There are payoff speeds often more than 800 m/min.
in application.
Flange Ø : 560-800mm
Multiwire : max. 8 x 0,35mm
Ø Cu-, Al wire : 0,15-0,9mm
Ø Steelwire hard : max. 0,4mm
Ø Steelwire soft : max. 0,6mm
Wire speed max. : 800 m/min
Wire tension : 3N - 25N |
 |
F21G-Gfk560/800HAT
Dancer regulated driven flyer payoffsThe
Payoff is equipped with a glass fibre flyer arm, driven by an AC-motor
controlled by a 4Q control unit and frequency inverter. Especially
suitable for high speed, start/stop use. Very even and constant tension.
Flange Ø : 560-800mm
Multiwire : max. 8 x 0,35mm
Ø Cu-, Al wire : 0,15-0,9mm
Ø Steelwire hard : max. 0,4mm
Ø Steelwire soft : max. 0,6mm
Wire speed max. : 800 m/min
Wire tension : 3N - 25N |
